Four Simple Steps to Oiling a Paper Shredder

Guidelines to oiling a paper shredder begin by determining the oiling needs of the gadget, utilizing the correct kind of oil, putting the right amount of oil, and spreading the oil.

Paper shredder gadgets are increasingly becoming popular in households and offices because of the security they provide from identity thieves. However, just like any other device, these gadgets require routine maintenance to constantly and effectively serve its function, such as oiling. Fortunately, oiling these machines is very simple to do. Just read this article to find out how.

Determine the oiling needs of the gadget

Depending on the degree of security your paper shredding machine can provide, the more secure it is, the more it needs to be oiled. Thus, in other words, strip-cut paper shredders need the least oiling, and those models used in high protection locations need the most. This is because the tinier the pieces of paper are shredded, the more dust is produced, which in time builds up on the cutting blades. Strip-cut paper shredders cut less paper compared to its higher end equivalents, and hence generate only less dust each time the gadget is used. Dust also normally accumulates over time and whenever the unit is often utilized. Most manufacturers would recommend oiling your unit every 30 minutes while being used to an hour. A good tip would be to oil the shredder about three to four times per week if you seldom utilize it, and to adhere to the instructions of the manufacturer if the unit is often used.

Utilize the right kind of oil

According to paper shredding phoenix, it is important to use the appropriate type of oil, one that is intended especially for your unit and suggested by its manufacturer. You can not just utilize any type of oil since the oil intended for these units are needed to be heat tolerant and must also have been calibrated especially for these units.

Apply the right amount of oil

Apply oil onto the blades, from one end to the other, at the blade opening for approximately 2 seconds. This should be long enough for the right amount of oil to lubricate the cutting blades, because putting on too quickly may result in an insufficient amount of oil, and too slow may also cause excessive oil on the cutters of the shredder. Paper shredder lubricating oils also come in different forms of containers. Thus, depending on its bottle, pour, squirt, or spray the oil onto the blades of the machine.

Distribute the oil

Spread the oil you applied onto the blades of the shredder by turning the machine on the manual mode and pressing the “Reverse” button. Let the blades run this direction for a few seconds, then hit the “Standard” or “Forward” button. Let it run in this track too for a few moments. Running the unit in both directions will enable the oil to be distributed throughout the entire shredder unit. After you’ve placed oil directly onto the blades, you may also shred a piece of paper with oil to be certain that oil gets to all parts of the cutting blades. To do this, just apply or spray a piece of paper with oil in a zigzag pattern. The zigzag pattern is essential to ensure that oil does not quickly get saturated into the paper before any of it can reach the cutting blades. You can also feed the machine another oiled piece of paper to be certain that the blades are now well lubricated.

It is essential that you utilize the oil suggested by the manufacturer of the machine so as not to void its warranty. In addition, if your unit has not been functioning properly, it is advisable to bring this to its service center instead of trying to fix it on your own.